Sewer Camera Inspection in Broward County, FL
A sewer camera inspection is the only way to know with certainty what’s happening inside your drain lines. Before recommending any repair — jetting, lining, or full replacement — we run a camera through the line and show you exactly what we see. Most inspections take 45 to 90 minutes. You get a clear diagnosis, not a guess.
What a sewer scope reveals
- ✓Root intrusion through pipe joints or cracks
- ✓Bottom-pipe corrosion in cast iron lines (common in pre-1972 Broward homes)
- ✓Grease and scale buildup restricting flow
- ✓Pipe bellies (low spots where water and debris pool)
- ✓Offset or separated joints from ground movement
- ✓Collapsed or partially collapsed sections
- ✓The overall grade and condition of the line
The four outcomes after a sewer scope
Every camera inspection ends with one of four recommendations:
1. Hydro jetting
The pipe is structurally sound but has significant buildup — grease, scale, or soft root intrusion. High-pressure water clears the obstruction without disturbing the pipe wall. Typical cost: $350–$650.
2. Pipe lining (CIPP)
The pipe has isolated cracks or minor joint separation but is otherwise intact and holds grade. A cured-in-place liner can seal the damage without excavation. Note: lining reduces pipe interior diameter — we explain this tradeoff fully before recommending it.
3. Partial replacement
One section of the line is damaged or collapsed while the rest grades well. We excavate only the affected section, replace it, and connect back to the sound pipe on either side. Less invasive and less expensive than full replacement.
4. Full line replacement
The pipe shows widespread corrosion, multiple failures, or grade loss along its full length. Full replacement is the only option that addresses the root cause rather than extending the life of a failing system. In Broward County, full underground replacement typically involves tunneling under the slab — a method that avoids breaking up flooring and passes 100% of city inspections.
How to prepare for a sewer camera inspection
Don’t use water for 30 minutes before the inspection — we need clear flow through the line so the camera has visibility. Have the cleanout access location available if you know it. If you don’t know where your cleanout is, we’ll locate it.
What a sewer camera inspection costs in Broward County
A residential sewer camera inspection in Broward County typically runs $250–$400. If the inspection leads directly to a same-day repair, we apply the inspection fee toward the repair cost.
Frequently asked questions
How much does it cost to put a camera in a sewer line?
In Broward County, residential sewer camera inspections run $250–$400. Some companies offer free inspections bundled with a repair — we charge separately so our diagnosis is never tied to upselling a specific service.
How long does a sewer camera inspection take?
Most residential inspections take 45 to 90 minutes from setup to written findings. Complex systems or homes without accessible cleanouts may take longer.
How does a sewer drain camera work?
A waterproof camera on a flexible rod is fed into the drain line through a cleanout access point. The camera transmits live footage to a monitor above ground. We record the footage and walk you through what we see in real time.
How do I prepare for a sewer drain camera inspection?
Avoid running water for 30 minutes before the appointment. Locate your exterior cleanout if possible. No other preparation is needed.
Schedule a sewer scope
Same-day appointments available Monday through Saturday, 7am–7pm.